Kepco DIN KIT RAX-50 (S) Bedienungsanleitung PDF herunterladen

Data subject to change without notice 228-1404

INSTRUCTION MANUAL

KIT

KEPCO

KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 "

FAX (718) 767-1102

http://www.kepcopower.com "

email: hq@kepcopower.com

An ISO 9001 Company.

DIN RAX

-50S

DIN-RAIL MOUNTING KIT

FOR SERIES RAX 50W

DESCRIPTION. Kepco KIT, Model DIN RAX-50S, contains two preassembled mounting clips and associated hardware

used to install RAX 50 Watt Series power supplies on a DIN rail. The S” suffix is for mounting along the short dimension

(width) as shown in Figure 1. Outline dimensions are shown in Figure 4.

FIGURE 1. S SUFFIX ORIENTATION

INSTALLING KIT. Attach the preassembled mounting clips to the power supply using the hardware supplied (see Fig-

ure 3). The clips may be mounted with the release lever on either side to facilitate removal.

INSTALLING POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both clips

under one edge of the rail, then snap the other end of the two clips into place (see Figure 2A).

REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, use a screwdriver to

apply leverage towards the left as shown in Figure 2B to disengage each clip from the rail. Where mounting clips are

close together, it may be necessary to apply leverage with two screwdrivers simultaneously.

FIGURE 2. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL

A -

INSTALLATION

B -

REMOVAL

1 2

2228-1404 062001KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-110

Keine Kommentare

Kepco DIN KIT RAX-50 (S) Bedienungsanleitung